Australia Popular Stud Track Roll Forming Machine

Australia Popular Stud Track Roll Forming Machine

Technical Data of stud track roll forming machine

1. Material thickness: 0.6-1.5mm galvanized coil
2. Decoiler weight: 3 ton manual
3. Rolling speed: 10-12m/min
4. Roller stations: About 13 stations
5. Roller material: GCr15 steel with quenching
6. Shaft material: No. 45 steel diameter 75mm shaft
7. Main motor power: 5.5Kw
8. Hydraulic cutting power: 5.5Kw
9. Cutting material: Cr12 with quench treatment, hardness 58-62
10. Electric source: 440V, 60Hz, 3 Phase
11. Machine weight: 3Tons
12. Way of drive: One inch single chain


Technical process

Decoiler— feeding with guide— rolforming—cutting—products collecting

Assembly and commissioning

Our engineer will visit buyer’s workshop for intall, commission and training. The customer should ensure the pre-installation being carried out appropriately. The buyer pays the round-trip air tickets, local cost in buyer’s workshop; Buyer has to pay USD 100 per day, per engineer.
Warranty
12 months warranty, starting from the date of the successful installation and commissioning of the equipment.

Machine Composition
 3 ton passive de-coiler 1 set
main roll forming machine 1 set
PLC control box 1 unit
 hydraulic station 1 unit
outer table 2 units

If you could send your detailed requirements to us, we can know how to make the quotation ans send it to you.

Leave a Reply

Your email address will not be published. Required fields are marked *